How To Do Your Own Garage Installation

Anyone taking on the job of doing their own garage installation will be faced with a complicated task. A garage door can pose difficulties, due to the way that they are large and heavy. Anyone good at doing work in their home, may come to find the whole process rewarding in the way that it is something they accomplish on their own, as well as allows them to save money.

Safety is something to always consider and means that you should not do this work if the door uses a standard spring system. The only types of doors that you should do yourself is those that use a torsion spring system. Additionally, this is something to keep in mind when you are removing a door as well.

These directions are to help with installing a sectional garage door, but should not replace the directions that came with the door. The very first thing you should do, relates to the application of the weather stripping to the bottom part of the first panel. Place the first panel in place and use something to temporarily keep it there.

Also put the hinges in, if you have not already. Then assemble the tracks according to instructions. After that ensure everything is right and then continue with putting in the rollers, as well as the brackets on the door section. Install the vertical tracks on the rollers after finishing with the installation of the brackets.

With the next section, you are really going to need someone to help you. At this point you need to lift the door and place it so it fits. After, put the rollers in and follow with the installation with the vertical tracks on each side. Attach the first section of the door to the second with the hinges. When you put in the third section, you should do it as you did the last section.

Check your work by referencing the instructions that you have. Seeing that everything is ok, then start with the installation of the top plates. These are attached to the wall for the vertical tracks on both sides of the door. During the time of installation, make sure its tight.

The track hangers should be attached to something that is solid, such as a ceiling joist. The track then is something that you attach to the hanger in a loose fashion on both sides. Now put the last portion of the door in and remove any nails that you used to hold the pieces in place. Depending on whether you plan to use a door opener, you will either put the torque tube in now or wait till later. If you are not using a door opener, then put the torque tub in according to the way specified in the direction and then put the door up about four feet in order to make sure the alignment is right and after making any necessary adjustments tighten all of the fasteners and you are set.

Looking to find the best deal on repair or installation for your garage or opener, then visit www.houston-garage-door.com to find the best advice on garage door service for you.